Acroprint Acrocomm program Handbuch PDF herunterladen (Seite 20)

Wand port

The Wand port is located on the lower left corner of the terminal.

It is a 6-pin DIN port which will accept a circular DIN connector.

The Wand, when connected, uses only 3 of the 6 pins available on

the DIN connection. If a Bar Code Gun (non-contact reader) is

used, the center pin supplies additional power. The terminal uses

2 of the remaining pins as logic lines for external controls. See

pin-out and function table below:

Pin Function

1 +5 Volts

2 Signal control logic line (special)

3 Bar Code Wand receive data

4 GND

5 Access logic line (special)

6 9 Volt unregulated

(maximum current draw 220 mA)

AND

485

232

END VIEW

6-pin DIN jack

Ports and connections

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Keine Kommentare

Acroprint Acrocomm program Handbuch Seite 20